I am having an issue with display sequencers. This is my first time using them so I am not 100% on how they work fully yet. I have a ride I am skinning and I have set up a rotating flashing light siren sort of setup inside the building. On the outside of the building I have a wavy wall that I have lights flashing in a wave back and forth. I have the sequencers set up correctly for each light sequence but I can not seem to get both to work at the same time. Am I doing something wrong? I have both sequencers set to run continuously and not activated on triggers.
2 Display Sequencers
- Thread starter RaYneMan1186
- Start date
Further Note: If I have one of them on activate by trigger and the other one is running continuously. As soon as I activate the trigger on the first the 2nd one stops until the first has played through its sequence then the 2nd one continues running on a loop as normal.
No the siren sequencer has small area lights attached to it and the wave sequencer has spotlights attached
Hmmm, then I don't know.
I was wondering if the lights where triggered at the same time from different sequencers that might cause this, but it was not.