3 BUGS so far in 1 single mission.

cyberus

C
1) On foot inventory transfer do not work. ( boarding en disembarking again can be used as work around)
2) Some magslots can't be cutted on internal lockers ( workaround getting code from panel)
3) Most terrible.... mission done ... boarding ship flying towards station some adder or cobra error.... back in game mission vanished ( no work around here) simply 45 mins wasted for couple on junk collected items on the way completing mission.

So far EDO experience is an average desapointment ( and no.... fancy terrain tech cant justify as succesfull launch all this tons of bugs that have been reported over and over in past 3 test stages and simply not fixed on release is simply incompetent work.)

Will see if next weeks will get some improvement.... rigth now it feels like Alpha test all over again.
 
Last edited:

danteuk

danteuk
cyberus said:
Will see if next weeks will get some improvement.... rigth now it feels like Alpha test all over again.
Click to expand...
It's Alpha again - it's beta - because it's feature complete - that's the difference.
For me I found:
I started in my SRV at a base, but I couldn't remember which pad my ship was suppose to be on - I tried all the garages but the boarding option never appeared so I had to self distruct.

Training mission first attempts, Corba never appear to pick me up - I had the voice telling to get on board but the ship wasn't there.
I re-logged - then the ship came down and I was able to board for a boring flight back to a station - but the disembark button wasn't available so I couldn't end it.

Then I tried to plot a route to a system, it plotted but when I clicked on the icon to show the system map all the icons disappeared and I was stuck in the gal map until I pressed escape.

Then the server died and my will to life ( at least in Odyssey ) died with them :(

Oh, and my frame rates where exactly the same as I got using the Alpha.

So far this Beta has been a little better than Alpha Phase IV but not as good as Alpha Phases I - III.
 

cyberus

C
Ydiss said:
The mag cutting works, it just sometimes takes longer. I've never had one fail on me.
Click to expand...
trust me... this one did nothing... usally its leave cutting line and indeed there is sometimes some spaces if you goin too fast..... but this time absolutely nothing. was cutting that slot like for 5-7 mins on the locker and not even animation showed up that edge was cutted. its just remained same.
Thouh it was only 1 locker that did refuse... other 3 did work as intended.
 
You must log in or register to reply here.
Back
Top Bottom