8A power distributor weapon focused

Hi,

Just wondering if i engineer my power distributor with weapon focused and cluster capacitors (because beams), will i lose some passive protection with 4 pips on SYS compared to the stock power distributor ?

thanks o7
 
The way I see it:

- pips to sys raise shield resistances regardless of distributor strength
- pips to sys raise the recharge rate of the shield, or rather limit the recharge by the maximum amount the distri can provide to the shield
- weapon focused/cc will provide your weapons with a higher recharge rate compared to charge enhanced, to the disadvantage of the other two (sys/eng)

so you shouldn't lose resistances, right?
(asking for a friend's to-be-engineered Mamba :D)
 
As above. For combat there are few reasons to use anything other than Charge Enhanced with Super Conduits. Go all in on the recharge.
 
Charge enhanced gives just as much increase to weps recharge or pretty close. With beams, the capacity is less important than the recharge. If you had some all PA load out planned I could see needing the capacity. PD mods need looking at by the devs because right now charge enhanced is kind of the universal right answer while the rest are pretty much only good for weird edge cases.
 
Back
Top Bottom