Animal doors

Hi every one :)
I love to build and make the exhibits as realistic as possible. that's why I like to make buildings where the animals can go in :) but for them to enter requires the hole to be quite large, I found out with the tigers. so my wish is that we get some doors or just holes the animals can get through without them having to be very big :)
 

Attachments

  • FB_IMG_1570745013373.jpg
    FB_IMG_1570745013373.jpg
    54.5 KB · Views: 863
  • FB_IMG_1570745010929.jpg
    FB_IMG_1570745010929.jpg
    53.7 KB · Views: 945
  • FB_IMG_1570745008234.jpg
    FB_IMG_1570745008234.jpg
    41.6 KB · Views: 592
  • FB_IMG_1570745004971.jpg
    FB_IMG_1570745004971.jpg
    57.7 KB · Views: 619
I hope people share their creations, like these on the workshop.

Pretty sure i'm not the only one struggling with the building tools or don't have the patience to make such an enclosure from scratch...
 
Agreed on the door sizes. I built an enclosure for my pronghorns that used the "door" building pieces and was frustrated to find that, although the pronghorns are significantly smaller than the doors, their navmesh didn't allow them to enter the building. (As seen in this video.) The final building still looked pretty good, I think, but I would've much preferred the smaller doors!
 
I was very confused when I've built my Elephant-House. The Entrance was 4m high but the Elephants couldn't get in. Then I found out that the Entrances weren't wide enough. But it looked like the Elephants should've been able to walk in
 
Agreed on the door sizes. I built an enclosure for my pronghorns that used the "door" building pieces and was frustrated to find that, although the pronghorns are significantly smaller than the doors, their navmesh didn't allow them to enter the building. (As seen in this video.) The final building still looked pretty good, I think, but I would've much preferred the smaller doors!
i did try with that door frames too for the Tigers, and they could not get through sadly :(
 
Back
Top Bottom