Cargo Transfer Bug

[Hugh Jardon]

Before I report it, is this a known bug?
When emptying my carrier of platinum, I can no longer transfer the 728T to my Cutter in one go, like I used to before. I have to do it in smaller unspecified and variable amounts. Sometimes it lets me transfer as much as 200T, other times less than 50T until the Cutter is full, so typically around 10 lots. if I try to transfer more than the unspecified and variable amount, I get a dialogue box with a warning triangle in it that says "Close". last night, I was doing my last run and had about 290T of platinum and 200T of Osmium to finish off. It wouldn't let me transfer the Osmium in any amount, so I still have it on my FC.

Is there a know cause for this or a workaround.? I don't have any problem transferring to my FC.

 

[Hugh Jardon]

Nobody else getting this then?

 

[BL1P]

Yes I have been having bugs like this with carrier cargo.
I dont know about a workaround or if its a known bug sorry.

 

[Yure]

its all seems to have started have the powerplay bug fixes.

 

[Jumpin' Jack Flash]

Hi All

Rather than starting a new topic I picked this one as it best describes this recurring bug, that seems to disappear and reappears after each new update.
Yes, there is workarounds and it's not critical to gameplay, most of the time.
The annoying thing is though that for example today I transferred over to my ship from the carrier a set amount of materials / metals for a mission requirement, I clicked on confirm transfer but I didn't double check that the transfer had been executed. Why would I?...as it recently worked as it's supposed to. On arriving at the station where the mission originated from I started to hand in the metals required only to find out there were no metals in my ships cargo hold.

Okay, as I said, it's not critical but it is rather annoying as obviously I had to repeat the whole process of going back to my carrier and transfer the required amount I needed again, this time double checking that the amount had been transferred correctly. On top of this there is also the exact same other bug the OP describes, as in having to transfer smaller amounts until the required full amount (or exceeding that amount) registers as being transferred. It's not working as intended, I usually figure a workaround but I'm exasperated now, patience is wearing thin as this is quite plainly a recurring problem....Why!

Jack