I have just been out in my Clipper, "in Odyssey" and went to land on the planet, lowered my landing gear and deployed my SRV, that lowered and I fell about 100 feet or so too the planet surface? looked up and my ship was well above the surface? so dismissed my ship in hope it would land correctly on a recall, did a little scanning and recalled my ship, and again 100 or so feet above the surface, but did manage to board my ship after some time, and was scooped up some 100 feet back in my ship, I have been out in other ships after the latest patch and had no issues, just with the clipper, any one else had this happen, I will try a few more ships to morrow...
Clipper landing issue
- Thread starter johnhoooton
- Start date
Yes I experience the same issue with the Clipper. Exactly what you say, gets dropped off at 100 feet or so. Luckily I was dropped on a low gravity planet. I haven't yet managed to get back on board.. The Clipper "lands" about 100 feet in the air making it impoosible to board. Obviously a bug.
Sadly even like the clipper as a ship, but decided to store the good stuff off the ship and sell, as I tested other ships and they all landed ok except the clipper, "I found out if you look up at your ship in the SRV you get a square
that you can line up to the boarding point, "takes a bit of practice" and you can then board, would no try this on foot?I also have this problem. I first noticed this beginning on 4-OCT-2021. Too bad. I have all the big three fully engineered and many other ships, but I still have the most fun in the Cutter. But dropping out from 100 ft then having to finesse positioning to get back on is a pain in the behind.
