Engineers Diamondback Scout stealth build advice needed...

I'm making a stealth DBS for PvP, just want to know your advice and any suggestion for loadout changes/improvements.

Here's my current setup:

Internals:
military grade alloys
2x C3 hull reinforcements
4A powerplant (G1 low emissions)
All other core internals A-rated
3A Fuel Scoop
2A Interdictor
No shields, this is a stealth build

Utilities:
3x Heat sinks
Chaff

Weapons:
2x C1 Railguns (G5 Long Range, Super Penetrator)
2x C2 Plasma Accs (G5 Efficient, Phasing Sequence)
 
Last edited:
Mod the armour and HRPs to be lightweight
Take off the fuelscoop when you arrive in the system you are pew pewing in
Maybe swap one of your penetraters to cascade
Phasing has been nerfed into the floor, so put lockbreaker and dispersal on your PAs
Mod your heatsinks and chaff for extra capacity
Maybe B rate your PP for extra armour
 
Last edited:
4A powerplant (G1 low emissions)

This is the one upgrade where the grade-1 version is better than the higher grades. If you take mats for enough rolls, you can get a good improvement on your heat efficiency as well as an increase in power.

I think you should have at least one module protection module.

If you don't mind the increased weight, the extra ammo upgrades for the heat sinks and chaff launcher are worth having. Though I think they increase the reload time.
 
Back
Top Bottom