Guests stuck in transport ride forever, ride stuck in limbo.

[Jeminyne]

As you can see in the attached image, the cars are all backed up and nobody will get in or out. I assume it's because the car in the lead, at the very mouth of the station, has nobody to get into it (there are no guests in line right now, at this station). So it will not leave. There needs to be a time limit on how long the cars can wait for guests, before moving on their own. There are guests at other stations waiting to get in, and they are waiting forever because of the empty cars at this station not moving along. Unless I am doing something wrong? Advice would be super appreciated.

 

[LN]

I can remember in Planet Coaster, with the Luna Cars, if they enter the station to fast, while there was still a car there, they would bump into each other, and causing the ride to stop working.

Did you set the station entry speed?
Can you lower the station entry speed?

 

[Jeminyne]

I can remember in Planet Coaster, with the Luna Cars, if they enter the station to fast, while there was still a car there, they would bump into each other, and causing the ride to stop working.

Did you set the station entry speed?
Can you lower the station entry speed?

you can lower the general speed the ride runs at. I don't think there's specifically an "entry" speed, but I will try lowering the ride's overall speed again.

 

[LN]

you can lower the general speed the ride runs at. I don't think there's specifically an "entry" speed, but I will try lowering the ride's overall speed again.

When you are building track, and have the station selected, you should be able to (at least if they use the same system as Planco has).
But reading your response, you didn't change anything there, so that would not be it.

Something other I thinked off, do you have a minimal load setup? If it is set to "full load" the car won't leave without a full load.
As the queue is empty, that might be it as well.