Hybrid Steel won't go past 85 degrees vertically

[newton82]

I just noticed while building a custom hybrid steel (RMC) that it won't go past 85 degrees to invert. But it does allow you build the pre-made pieces like a cobra roll or loop.

 

[Crowdpleaser]

I just noticed while building a custom hybrid steel (RMC) that it won't go past 85 degrees to invert. But it does allow you build the pre-made pieces like a cobra roll or loop.

It won't do that in one go, but if you place the piece you will notice that you can bend the next piece even more. You can create pretty much every special Track Piece by hand.

 

[LN]

Yeah, all pieces can have an maximum angle of 90 degrees. So if you started the piece with a -5 degree angle it can become maximum 85 degrees.

 

[Bullethead]

Sometimes you also have to fool the interface. When the end of your track is pointing up 90^, you can't bend the next piece on the vertical axis any more sometimes---it's stuck at 90^. But you can bend it hoirizontally and put bank in it, and eventually break the stalemate and pull the track over the top of the inversion that way.