i cant get my supercharged frameshift to work

[williams1]

ive tried everything. it still says 26ly when i try and plot a route. what is going on?

 

[[VR] Orodruin]

Did you get the message that your FSD had been supercharged?
Have you turned on use FSD boost for your plotting?
Have you tried just selecting a system within your new range and engaging the FSD?
Can you provide a screenshot of your jump range and a build link?

 

[SlickPBW]

Fuel scoop installed?

 

[Kenneth McGrew]

• fuel scoop installed
• you have actually supercharged it
• you have gone back to the map and re-plotted the route
• you have enabled supercharged in your route plotter settings (as this will also cause issues)

 

[nafnist]

It needs to say Frameshift Drive Supercharged, before it is actually charged up.

 

[Miko]

ive tried everything. it still says 26ly when i try and plot a route. what is going on?

Check the galaxy map and account for any reduction due to cargo. In the search tab down bottom, cargo mass bars.

 

[Vasquess]

After successful supercharge, i.e. in deed you hear your COVAS saying "Frameshift Driver Supercharged" while in the jet cone, have a look in the right-hand panel into your ship stats. There you can find the max. jump range of your ship. When supercharged, it is 4x the distance after charging at a NS and 2x the distance when charging at a WD (be careful at WDs they are more dangerous for reasons). Keep in mind that supercharging is only for the very next jump (not your hole fuel tank becomes supercharged stuff).
When looking at the galaxy map and have the supercharged enabled in your route plotter you will see some blue segments in the planned route. Theses indicate that there you can do a charged jump. But it requires you to do the jet-cone supercharging thing when you are in the system where the blue segment starts.
(If you already knew all this… never mind; good luck and that you never exit supercruise when in the cone!)