New shield experimental.

It's been several years since the old random roll system for the engineers has been gone and it took a very useful secondary effect with it, increases to optimal hull mass.

Shortly after the new system was implemented Frontier stated that they're "looking into it" in one of their livestreams, but there's been nothing since then.

So I propose this new experimental.

Oversized projectors: Upgraded shield projection units increase the optimal hull mass rating of the shield generator, at the cost of increased power and SYS draw, as well as a slight reduction to all damage types, (EDIT) as well as slower regeneration rates.

Stats;
20% increase to optimal hull mass.
25% increase to power draw.
30% increase to SYS draw.
3% reduction to kinetic and explosive resistance, 6.5% for thermal.
EDIT: 10% decrease to both active and broken regen rates.

This effect would re-enable C5 shields on a Cutter and T-10, as well as allow the Federal Dropship trio to use shields with an optimal mass rating higher than their hull mass

It would also give an alternative to the high capacity experimental for those who want more raw shield strength, but with higher downsides.

Edits: Added additional regen downsides, emphasizing raw shield strength increase vs other experimentals.
 
Last edited:
20% is a bit much, the old effect hovered around 10% increase, enough for the Cutter. But basically I fully agree. It really bugs me that I can run a Cutter with a size 5 prismatic, because I was around in the old days and rolled that special, but newer players can't.
 
I'd be fine with it only being 10-15% but the 20% increase is for the sake of the FAS. A C5 shield would then have an optimal mass of 486 tons, 6 more than the FAS's hull, meaning it could finally mount an optimal shield.

Edit: I've added an additional downside to the experimental effect in the OP.
 
Last edited:
Back
Top Bottom