Oculus Rift CV1 Sensor Mounting

[Loworbit]

Hey commanders. I switched from the DK2 to the CV1 and had a real headache with the two sensors. The standard stands wouldn't fit in my room, as I have nearly zero space to place the senors.
There are some mounts on Thingiverse but I liked non of them because the thread of the sensor isn't M6 but something else (maybe some inch and foot stuff). M6 would strip the threads so I designed a clamping mount and printed some.

I uploaded it to Thingiverse, feel free to print or edit as you like. You may also use Shapeways and let them print it for you.
If any german people needs a mount, get it for in beer in Hamburg/Germany. Printed in black PLA, very sturdy.

 

[Filmgeek47]

Nice!

I went very simple with mine because I was impatient! Just some right angle brackets from home depot and some threaded 1/4-20 screws. Like $8 total. My sensors didn't like being mounted upside-down (I've read a lot of conflicting advice on this so YMMV) so I just used some pliers to bend the brackets down.

 

[Loworbit]

Booth sensors are mounted upside down without any warnings or errors in the Oculus software or in E. Head tracking and the touch sensors are working flawless. Oculus software didn't like the spacing (more than 2 meteres away from each other) but I just ignored that.

 

[Orvidius]

Nice! I mounted mine slightly differently. I got a set of these, and mounted the sensors to the wall, just below the ceiling. It allowed me to mount them upright, rather than inverted, not that it really matters.