Placement of water bodies and sudden loss

Big-Rich1

B
Could use some help, please.. What happen while placing a few water bodies i i have effectually removed one other .. I have attempted in getting it back but to no avail. Has anyone encountered this problem if so .. a simple fix or is this a bug un-yet discovered till now? If at all possible a step by step solution please. When saved i save on-top of the existing park therefore i cannot go back.. Thank you for your time
 

jamesviago

jamesviago
Pictures would help. But short story is that water is a surface, and if is within roughly 2m of another water surface, they merge (or one is deleted).
If you find the place the terrain causes the surface to interact with the one your trying to place, and make the gap bigger, you'll get it back.
 

Big-Rich1

B
jamesviago said:
Pictures would help. But short story is that water is a surface, and if is within roughly 2m of another water surface, they merge (or one is deleted).
If you find the place the terrain causes the surface to interact with the one your trying to place, and make the gap bigger, you'll get it back.
Click to expand...

You will see as i have given description...

I have placed all bodies of water without incident .. The last thing i did was to place a ride. no water.. I have removed the ride and attempted to return water .. fruitless Water.jpg

- - - - - Additional Content Posted / Auto Merge - - - - -

Thank you for your help
 

LN

LN
Big-Rich said:
View attachment 888 The picture you had requested follow up post bellow... Thank you for your help
Click to expand...

Did you alter any terrain near your paths?

There should always be a a small flat area next to the path to prevent it getting to close.

This is where I always lose my water. When I smooth the terrain near paths. It does not like to get close to them.

Using ctrl-Z didn't work at that moment you lost the water.

My advice:
always use ctrl-Z after accidental removal of water. It's easier than trying to place the water back.
It also makes it a bit clearer to see where the issue was/is.
 
Last edited:

Big-Rich1

B
Luuknoord said:
Did you alter any terrain near your paths?

There should always be a a small flat area next to the path to prevent it getting to close.

This is where I always lose my water. When I smooth the terrain near paths. It does not like to get close to them.

Using ctrl-Z didn't work at that moment you lost the water.

My advice:
always use ctrl-Z after accidental removal of water. It's easier than trying to place the water back.
It also makes it a bit clearer to see where the issue was/is.
Click to expand...

Thank you
 

rforeman

R
I think Luuknoord is correct. It is most likely something to do with the paths. Just from looking at the picture. Try removing the paths where they are going over the water and see it lets you place the water.
 

Big-Rich1

B
rforeman said:
I think Luuknoord is correct. It is most likely something to do with the paths. Just from looking at the picture. Try removing the paths where they are going over the water and see it lets you place the water.
Click to expand...

Thank you

- - - - - Additional Content Posted / Auto Merge - - - - -

Thank you all very much for your help It is very much appreciated.
 
You must log in or register to reply here.
Back
Top Bottom