Horizons Please, how to : Install a surveillance software on the Comms Arrays

Cthulhus

Cthulhus
Hello, again, a mission that normal humain can't understand on Elite... Could you help me please?

The mission said this : Install a surveillance software on the Comms Arrays at Rosenberg Silo...
I destroyed all turrets and defences, now I can move on the base.
But NOW, what to do ???????????????
Again, Frontier have a BIG BIG BIG BIG lack on the mission details..

Attached two pictures ;
I try to "scan" some equipments but that don't work (or I can't know how to use the scanner on the SRV) - again, no instruction... Émoticône frown
Thanks

Capture d'écran 2015-12-16 10.47.44.jpgCapture d'écran 2015-12-16 10.48.43.jpg
 

Malek

Malek
Use your data scanner on the appropriate data point, probably located next to the comms array. Make sure you have it assigned to fire group, you do need to hold it pressed for a number of seconds
 
Last edited:

Cthulhus

Cthulhus
I'm sorry but that don't work...

Comms arrays selected, but no action, nothing at all when pressing the button...
 

Heater

Heater
Make sure you have the scanner mapped int he configuration, and assigned to a fire group, then select the mast (you will see something like Nav point when you have it locked) then hold down the button / key that you have mapped, it takes a few seconds for the scan to complete.
 

Iskariot

Iskariot
Brownshortz said:
as well as putting it into a fire group, go to control set up and set "press fire to deploy hardpoints" to ON.
Click to expand...

Yes this is most likely the culprit. It took me a while too to discover what was going on.
I hate it that I had to change this setting, because it can potentially cause some awkward situations.
 
You must log in or register to reply here.
Back
Top Bottom