Sinking a blue printed coaster?

[corpkid]

I created an inverted coaster and saved it to a blue print. The coaster had a lot of tunnels and underground parts. When I place this blueprint however, I am unable to pull it down into the ground (and create tunnels, etc).

Is there any way to do this? As it stands my coaster is too high to place unless I sink it down a little bit. Thanks!

 

[cerealfruitcakes]

Your only option right now is to dig holes where you want it to go under, place the ride and then bury it. Hopefully they do have an option later allowing us to tunnel blueprints.