Greetings, dear Commanders!
I've purchased a Thrustmaster Warthog with TMRP and am very satisfied with this cool piece of hardware. Never felt such control over my ship with the X52.
Now, that I'm used to cotrol my ships FA-On I would get into FA-Off. I read something about to scale the axis-response to get proper inputs without oversteering too much.
I configured all axis so far, that it gradually increases the input value the farther I "pull/push" the stick.
So far so good. Now I'm stuck with the GUI. I "activated" my (passive) USB-Hub, where all TM-devices are stuck into, but as soon as I want to run my Elite-Profile the gui is stuck within device-recognition for litterally dozens of minutes (I guess,during receiving the Device-IDs from the USB controller). All I can do is to task-kill the GUI. What have I done wrong? Could it be that all Warthog devices are plugged into the same hub? I'm pretty sure that I didn't mess up the software-installation because I followed all the instruction that were provided by Thrustmaster itself.
So, I would appreciate any tipps how to get this stuff working properly.
Thanks in advance!
P.S.: Without starting the gui, the Warthog runs perfectly with Elite.
I've purchased a Thrustmaster Warthog with TMRP and am very satisfied with this cool piece of hardware. Never felt such control over my ship with the X52.
Now, that I'm used to cotrol my ships FA-On I would get into FA-Off. I read something about to scale the axis-response to get proper inputs without oversteering too much.
I configured all axis so far, that it gradually increases the input value the farther I "pull/push" the stick.
So far so good. Now I'm stuck with the GUI. I "activated" my (passive) USB-Hub, where all TM-devices are stuck into, but as soon as I want to run my Elite-Profile the gui is stuck within device-recognition for litterally dozens of minutes (I guess,during receiving the Device-IDs from the USB controller). All I can do is to task-kill the GUI. What have I done wrong? Could it be that all Warthog devices are plugged into the same hub? I'm pretty sure that I didn't mess up the software-installation because I followed all the instruction that were provided by Thrustmaster itself.
So, I would appreciate any tipps how to get this stuff working properly.
Thanks in advance!
P.S.: Without starting the gui, the Warthog runs perfectly with Elite.
Last edited: