Logitech X56 - Help
- Thread starter Jettnett
- Start date
The four mounting holes on the corners of the joystick and throttle are 6 mm or 1/4 in diameter designed for flat head screws if
that helps. Me, I use cut to fit non-skid grip kitchen shelf / drawer liners on the desktop to minimize movement or to move them
out of the way when not playing ED. It also allows repositioning when the body gets tired playing ED for many hours.
that helps. Me, I use cut to fit non-skid grip kitchen shelf / drawer liners on the desktop to minimize movement or to move them
out of the way when not playing ED. It also allows repositioning when the body gets tired playing ED for many hours.
Last edited:
I used 6mm T-nuts and 6mm Allen bolts with flat washers on mine. I marked the hole positions on my desk, drilled through, placed the T-nuts on the desk underside and after putting it all in place tightened the allen bolts securely. I went this way as it is very easy to over tighten countersunk screws and break the plastic of the throttle and joystick bases.
Where did you buy one. I have been searching all over the place.
Just be aware that unless your running something like a powered USB Hub or Powered PCIE card, the power draw from the throttle can cause ghost touches. It can be infuriating if your unaware of the issue, when suddenly your shields drop during combat! Even with a 2 slot sata powered PCIE card I use for the X56 alone, I can still randomly experience it, but a quick unplug and re-plug the issue is gone again for a few months!